top of page
Concrete Wall

Step cracks
Step cracks


Step cracks


Frequently Asked Questions about Foundation Settlement:


Q: Is foundation settlement repair a DIY (Do It Yourself) project? Can I hire a handyman for the job?

A: I often receive these questions from my clients, and the quick answers are both "No." Foundation problems, including settlement, should always be addressed by a professional with the necessary expertise. My recommendation is to hire an unbiased and impartial professional to assess and provide their evaluation and opinion. It's best to avoid salespeople who might push their company's services or products. Each situation is unique, and some issues may require addressing the root cause, while others may involve stabilizing the foundation after correcting the underlying problem.


Q: What is the primary cause of foundation settlement?

A: Foundation settlement can be attributed to several factors, with changes in soil moisture content being a major contributor. Let's explore this further:


Drying: Soils tend to shrink during dry periods, especially in regions with excessive vegetation around foundation walls or where trees draw significant amounts of water from the soil. As the soil dries out, it develops voids (air gaps) that can collapse. When the soil beneath your foundation walls becomes excessively dry, settling occurs, leading to foundation settlement.


Wetting: This occurs during heavy rainstorms or flooding when the soil beneath your foundation becomes oversaturated, particularly with clay-type soils. Poor drainage can exacerbate the issue, preventing water from draining away from the foundation.


Plumbing Leaks: Leaks in water or wastewater pipes due to factors like broken pipes or root intrusion can saturate the soil around your foundation, contributing to settlement.


Voids in Fill Soil: Often, builders disturb the soil when grading the ground before constructing a foundation. Loose fill soil is commonly used and may not achieve the same density as the original soil. Without proper compaction, voids remain in the fill soil, leading to future settlement and affecting the foundation.


Differential Settlement: This form of settlement occurs when one side of the house settles more than others due to localized issues. Factors like the presence of a large tree near one corner, a broken downspout drainpipe, a water leak, or negative grading can significantly impact the soil, leading to differential settlement.


These are some of the major factors contributing to foundation settlement. While we've covered several key elements, it's important to note that addressing every condition is beyond the scope of this educational blog.


If you have questions or concerns about your foundation, please feel free to reach out to us at Contact Us We're here to help.


Step cracks
Step cracks

Picture shows both signs of a bow and settlement







Written by Firas Abdelahad, P.E.

Firas Abdelahad has been a practicing structural engineer since 2005, collaborating with a diverse range of professionals, including consultants, architects, investors, homeowners, contractors, and subcontractors. Together, they tackle the various challenges that can arise during the design and construction phases of projects.



The information and statements in this document are for information purposes only and do not comprise the professional advice of the author or create a professional relationship between reader and author.









November 2020


Sagging Floor
Pittsburgh Design & Engineering Services- Floor Sag

At Pittsburgh Design & Engineering Services, we were recently consulted to evaluate a significant floor sag in a single-family home located in the South Hills area of Pittsburgh. Our detailed assessment revealed critical structural issues stemming from unprofessional modifications made to a load-bearing beam.


The Structural Challenge (Sagging Floor)

The homeowner reported a noticeable sag in the first-level wooden floor. Using precise leveling tools, we measured a deflection of approximately 1 inch over a 4-foot span. Upon further investigation, it became clear that a previous homeowner had altered a load-bearing beam without proper structural analysis. This modification severely compromised the home’s structural integrity, leading to the visible floor sag.


Our Expert Solution

To restore the home's structural stability, we recommended replacing the compromised beam with a properly sized and structurally sound alternative. A Laminated Veneer Lumber (LVL) beam was identified as the ideal solution due to its high strength and reliability. The beam's size and capacity will be carefully calculated based on span length and tributary load requirements. In some cases, a steel beam may be considered, provided installation logistics align with the project constraints.


Proper installation is critical. This process involves leveling the support system, which may require carefully lifting the floor joists to eliminate sagging. We strongly advise hiring a licensed, insured and experienced contractor to ensure precise installation and compliance with local building codes.


Why Professional Guidance Matters

Structural issues like this are increasingly common, particularly in flipped homes where cost-saving practices or lack of experience may lead to improperly altered load-bearing walls. Removing or modifying structural elements without consulting a qualified structural engineer can result in costly damage and safety risks.


If you're planning to remove a wall and are unsure if it's load-bearing, or need expert guidance on sizing and installing an LVL beam, Pittsburgh Design & Engineering Services is here to help. Remember, most municipalities require permits for structural modifications—compliance with these regulations is essential for your safety and peace of mind.


Protect Your Investment

Your home is more than just a structure—it's your sanctuary. We prioritize your safety and the long-term stability of your home. Reach out to us for expert structural assessments, professional guidance, and code-compliant solutions.


Contact Pittsburgh Design & Engineering Services today to safeguard your home and make informed, confident decisions.


Picture below shows the improperly modified beam:


built up beam-not proper
"built up beam"



Written by Firas Abdelahad, P.E.

Firas Abdelahad has been a practicing structural engineer since 2005, collaborating with a diverse range of professionals, including consultants, architects, investors, homeowners, contractors, and subcontractors. Together, they tackle the various challenges that can arise during the design and construction phases of projects.


The information and statements in this document are for information purposes only and do not comprise the professional advice of the author or create a professional relationship between reader and author.

724-949-0004

412-677-0933

Email us

P.O BOX 112634

Pittsburgh PA 15241

  • Facebook
  • LinkedIn
  • Pittsburgh Structural Engineer- Instagram page
  • TikTok
  • Pittsburgh Structural Engineer- YouTube Channel

© 2019-2025  Pittsburgh Design & Engineering Services LLC. All Rights Reserved

bottom of page